Blanket insulation

Type
Insulation Materials
Where Applicable
Installation Method(s)
Advantages
Blanket: batts and rolls
•Fiberglass
•Mineral (rock or slag) wool
•Plastic fibers
•Natural fibers
•Unfinished walls, including foundation walls
•Floors and ceilings
Fitted between studs, joists, and beams.
Do-it-yourself.
Suited for standard stud and joist spacing that is relatively free from obstructions. Relatively inexpensive.

Installing fiberglass insulation

Comments

  1. UnknownOctober 9, 2017 at 10:07 PM

    Looks very uniformed, do not like how this is set up, all 3

    ReplyDelete
  2. UnknownOctober 9, 2017 at 10:08 PM

    Looks very uniformed, do not like how this is set up, all 3

    ReplyDelete

Post a Comment

Popular posts from this blog

Cellulose dust

Dust from cellulose insulation can irritate the eyes, skin, and respiratory system. Potential Symptoms Irritation of eyes, skin, mucous membranes;  blocked nose, dry nose, sneezing;  hoarseness, cough and phlegm;  exercise-induced dyspnea Safety and health checklist If there is existing insulation that is deteriorated, wet or moldy, it should be removed.  If there is already blown-in insulation in place, cellulose can be blown over the top.  In attics with fiberglass batts, the batts should either be removed, or the cellulose blown under the batts to make contact with the ceiling below.  For best performance, the cellulose should cover any existing insulation and framing.  Wear a dust mask and goggles.
Read more

Insulation incident report

Image
A 42-year-old contractor was insulating the roof of a steel boat storage shed when a strong gust of wind caused him to lose his balance. He fell 26 feet onto the stone floor and died as a result. What happened? The contractor was an employer of an insulating crew of three employees. He had 22 years of experience in the insulation trade and had been working this particular contract for 5 weeks. General work practices were reviewed with employees at the time of hire, but no formal safety training was provided to new employees. The contractor was hired to insulate a Butler building approximately 80 by 200 feet with strips of fiber glass that measured 82 by 3 feet, 3 feet thick. The insulation was laid down on the bar joists of the roof and covered with metal decking. The insulators stood on the finished portion of the roof as their work progressed. Neither the contractor nor any of the crew members used any safety or fall protection. No static lines were installed in the building ...
Read more